Real Estate

Extra tall Office Partition Systems – Items to consider Ahead of Acquiring

 

Under some conditions, a large partition system that extends from a floor to the ceiling is desirable to control the noise in an office environment. There are certain issues that need to be addressed before investing in such a partition system.

One issue is fire safety. A high system that blocks the exit signs, fire extinguishers, sprinkler system or audible alarm noise could be deemed unsafe by the neighborhood fire marshall. This could require its removal or modification to meet the neighborhood fire codes, per the Fire Marshalls demands.

One assumption that is dangerous, is convinced that you know your ceiling height. You might think that you know the ceiling height, but a careful measurement is required. Ceilings tend to sag in unsupported areas, and could vary by an inch or more in various places. It is important to gauge the distance from a floor to the ceiling, wheresoever the panels will meet the ceiling, to make certain that the panels will fit divisoria piso teto. In cases where you’ve an average “drop ceiling” the height may be adjusted upward, by twisting the support wires holding the ceiling framework. In case of a great ceiling, you don’t have this option. The panels should be slightly shorter compared to the ceiling height, or they will not fit.

Then there is the matter of air flow. Office environments will most likely have some kind of ventilation provided by the air conditioning or heater, or perhaps just windows. Enclosing a proposed office with a floor to ceiling partition system could impede the airflow compared to that section and require venting. Venting by way of low and high vents can accommodate some minor degree of convection. As hot air rises, it can flow from the propose office through the high vents and thus produce a slightly lower air pressure at the end, where cooler air can flow into the proposed office through the reduced vent. A reliable panel manufacturer should be able to provide the vents, built into the panel system to allow for airflow into each office.

Lighting is another concern. Panel systems are normally opaque, so they really block light. If an office has its lighting then the issue is mostly solved. However, if your propose office does not have lighting, then some kind of window arrangement built into the panel system could be needed to supply some light for the reason that office. It’s advisable to take advantage of natural lighting that comes through skylights, or windows facing outside. In case a partition system has built in windows in strategic locations that accommodate the usage of outside natural lighting, then this will reduce timeframe where in fact the electric lights are turned on throughout the day, thus reducing your energy consumption.

One justification that tall partition systems are utilized would be to supremely control the noise. Short panel systems are not so with the capacity of this, as sound travels as a “wave”, and simply explains the the top of panel systems and travels throughout the office, until absorbed by soft treatments, such as for example carpet, drapes, and other absorbing structures. However, sound waves can transfer by way of a panel system too. The materials used in the panel is of concern to those seeking maximum noise reduction. Think about this: Sound travels most efficiently through dense, hard mediums. Thus, sound travels better (and faster) through water, than air. Hard mediums can transfer sound a lot better than soft mediums. Another example of this is considering ballistic plastics. A glass surface is hardly bullet resistant because it is hard, and brittle. It cannot withstand the kinetic energy of a bullet, since it cannot flex enough to absorb the vitality without breaking. Polycarbonate is an application of clear flexible plastic. Polycarbonate is more bullet resistant than glass, because it is more flexible, and can absorb the impact bette, without breaking. For that matter, Kevlar fabric is bullet resistant largely because of it’s mixture of great flexibility and high tensile strength.

Leave a Reply

Comment
Name*
Mail*
Website*